cancel
Showing results for 
Search instead for 
Did you mean: 

SZ100 not pinging after reset

abdullah_zia_76
New Contributor III
i am changing the management ip to 192.168.1.1 to another network 192.168.11.1 but got error message something like "ip cannot change static route not defied  " like that

than I reset the ZS100 and now its default ip is not pinging and status light is gree.
5 REPLIES 5

martin_martin
Valued Contributor
Hi,
I assume you mean the SZ100
If so, take a console cable and connect it up, and check via serial link.

Login to the device and do a show interface.
This will give you the current ip address assigned to the device.

Kind regards
Martin

abdullah_zia_76
New Contributor III
i connected the cisco console with com1 port but no response

abdullah_zia_76
New Contributor III
the status led is red when port 1 not connected to any switch.
status led turned red when port 1 is connected to switch
????

martin_martin
Valued Contributor
Hi Abdullah,

Do you have the serial connection good ? and also like putty to comx: ?

If so, power off the SZ100 and wait 10 sec, and then back on. You should see the bootup process of the unit.

Kind regards
Martin