Get CLI config files of ZD ,like cisco's show run

[mark_lee_700221]

I want to use a cli like cisco's 'show run' to get the cli configuration. And then enter this configuration to a new deivce by CLI.

I know the show config, but it is not a kind of CLI command. 't re-enter the output of "show conf" to restore a config.

[john_d]

The ZoneDirector stores it's config in a database that you can back up then selectively restore (e.g. Configuration only) via the WebUI. Is doing it at the command line a must?

[mark_lee_700221]

Thanks for your reply. Yes, if it support backup cli configuration could be better.
You means ZD does not support this feature?

[michael_brado]

Neither ZoneDirector nor Standalone APs have a complete text configuration file backup/restore capability. You can script some CLI configuration of common settings or WLANs, but not a full backup/restore file.

You can save a configured ZoneDirector backup file, and install it on a new ZD,
leaving that ZD's IP address and login credentials, in order to "clone" another/new
ZD with an existing/working configuration, which is sometimes helpful. This is
done thru the ZoneDirector WebUI too though, not a CLI method.

[mark_lee_700221]

Thanks!