09-10-2020 12:17 PM
First I just want to say thank you for adding this to Unleashed! I have configured a Profile for this and enabled it on a WLAN, but I am not seeing my Wi-Fi Calling Client, even after refreshing, on the Summary tab even though I’m currently on a Wi-Fi Call. How do I go about troubleshooting this?
Thank you!
09-11-2020 02:10 PM
To access the AP CLI from the Unleashed Master (controller) CLI, use the following command:
ap-mode
ruckus# ap-mode
You have all rights in this mode.
ruckus(ap-mode)#
09-11-2020 02:14 PM
Thank you again Tony!
I was able to connect to the relevant member AP and see the following in real-time:
rkscli: get rflowWe look good 😉 !
| flag | age | MAC1 MAC2 | IP1 IP2 | proto|PORT1 PORT2 | flow ID | 1tx 1rx | Deny | QoS | R/L | URL | APP | 2tx 2rx | retry | UTP | ifname
...
| 4C0060D | 0 |9D9E 1EDA| 208.54.37.80 198.51.100.200|UDP| 4500 42670 | 25808 | 22800 2528 | ALLOW | 2 3 1 3 | -1 -1 | -1 | T-Mobile |2528 22800 | 3|0 | wlan34 eth0
09-26-2020 10:51 AM