We currently have an unleashed network with 3 AP's. Two R500's and 1 R610. It's been awhile since an AP was added and I recall it was really simple, plug and play almost. Now I'm trying to add an R650 AP but the unleashed network does not see it. I scanned the network and the device is getting an IP and I'm able to ping that IP using the ping utility built into the unleashed GUI. After poking around I see that the unleashed network does see the AP but only when I goto Admin & Services -> Administration -> Upgrade. I'm currently running firmware 220.127.116.11.127 and it says I have an update available for 18.104.22.168.141. Before performing the upgrade I wanted to check and see if anyone could confirm if I see the AP listed on the upgrade page, is it safe to say that it will also be updated and eventually allow me to add it as another AP? TIA !!!
Hi @michael_antes I see that the Master AP is able to ping the new AP. Could you please confirm if the new AP firmware is same as the Master's? If yes, try doing a Factory reset on the new AP and try connecting to the network so that it can talk to the Master. You can also login to the new AP CLI (SSH) and issue the below command to set the Master's AP manaully. set director ip x.x.x.x