cancel
Showing results for 
Search instead for 
Did you mean: 

Unleashed issue

Tech
New Contributor

Hello, I am trying to join an AP R610 and R650 in unleashed mode, but for some reason, the second access point (not the master) always appears as disconnected, I try to ping between them and it is not successful, both are in the same network, there are no firewalls or anything that is blocking the traffic, I am using my PC when I ping both is satisfactory, has anyone had this problem?

Note: the access points have the latest firmware and I did a factory reset on both

1 ACCEPTED SOLUTION

Tech
New Contributor

Thanks for your help, I fixed it, there was some problem in the CAM table on the switch (MAC - Layer2), and now both APs are working. 👍

View solution in original post

2 REPLIES 2

Squozen
Contributor

IP conflict with another device on the network? That’s all I can think of. Maybe your PC is actually pinging something else when you’re testing. 

Tech
New Contributor

Thanks for your help, I fixed it, there was some problem in the CAM table on the switch (MAC - Layer2), and now both APs are working. 👍