Rukus R599 Unleashed AP loose their configuration

[shaun_van_tonde]

Any help would be appreciated.

I am deploying 3 Ruckus Unleashed R500 AP's to our second site.

I setup the first Rukus AP and it became the master with no issues

Additional AP configured with the same IP address range, mask gateway etc also form part of the unleashed network. They seem to work for a while but after a reboot or power loss on the connecting switch the access goes back to configure me mode and the IP reverts back to 192.168.0.1.

All AP are running this version of firmware: 200.3.9.13.228.

My steps below:
setup master AP 10.1.102.100 255.255.255.0  Gateway 10.1.102.1

Unbox new ap. Connect to configure me wireless broadcast.
Update firmware to match master AP.
Login via putty to unleashed.ruckuswireless.com

Run these commands:
set dns 10.1.31.6 10.1.6.6 (internal servers)
set country code ZA
set ip addr wan 10.1.102.101 255.255.255.0   10.1.102.1

Reboot:

Ap becomes part of unleashed network and works fine.  Later either on its own or after a switch reboot or unplug of the AP the AP goes back into configure me mode and IP address is once again 192.168.0.1

This is driving me insane. Could anyone assist.

What could be the issues.