R700 & R500 Unleashed - Can I use the Ethernet port to bridge to WAN?

[ricardo_rivera_]

Good morning,

At home I'm using an R700 (Master) and R500 (Mesh) on unleashed mode. I would like to know if I can use one of the ethernet port on the R500 to connect a PC(with no wifi) to get internet. 

Right now I connect the PC on one of the port and I don't get any ip. I assigned a static ip to the PC and I still can't get out to the internet.

Could this be posible on this setup?

Thanks in advance!

[ricardo_rivera_]

HI Michael,

Al my devices do get ip connecting to unleashed wlan. the only devices that doesn't get any ip is PC-no-WIFI when I connect it to the r500 eth1 or eth2. I just get a ghost ip. I even try setting the ip manually on the pc-no-wifi but it didn't work... it like the Ethan port are no bridge with the wlan.

I will try connecting to the r700 Eth port to see If a get the same result...

is there anything to see if the Eth port are bridge to the wlan? since the unleashed is running I can't get any access to the ap setting  web gui... I just get the unleashed dashboard..

I don't know much about the CLI but is there is away please let me know.

thanks

[ricardo_rivera_]

Thanks you all! yesterday i got home and try it again and it started to work. I don't know why it didn't work or why it started to work. i haven't make any change but it si working!

so thanks again!