R700 & R500 Unleashed - Can I use the Ethernet port to bridge to WAN?

[ricardo_rivera_]

Good morning,

At home I'm using an R700 (Master) and R500 (Mesh) on unleashed mode. I would like to know if I can use one of the ethernet port on the R500 to connect a PC(with no wifi) to get internet. 

Right now I connect the PC on one of the port and I don't get any ip. I assigned a static ip to the PC and I still can't get out to the internet.

Could this be posible on this setup?

Thanks in advance!

[michael_brado]

You should get DHCP for your client PC connecting to the extra Eth port of either AP...
Do you have a network LAN switch, and will your PC get DHCP from one of these ports?

[ricardo_rivera_]

I just added a diagram of what I would like to do... please let me know if that is possible or not. Thanks!

[ricardo_rivera_]

Thanks for the reply! please se the diagram.

All my device do get DHCP from my router when using the wifi. Mesh is working fine! But i would like connect the PC that has no wifi to the R500 using one of the R500 ethernet port to have internet on it... when i plug it in i don't get any ip. so i don't know if that is even posible..

 i don't want to buy wifi card/usb for the pc since the ap is next to it.

[monnat_systems]

hi


please chk this similar post

https://forums.ruckuswireless.com/ruckuswireless/topics/client-bridge-ruckus-or-other

also try this command -

set qos directedDHCP disable

command syntax might be different in unleashed so please double check