When an H510 is running in unleashed mode and acting as master, there seem to be no options in the configuration interface to configure its 4 Ethernet ports. I am afraid this is just unsupported as of release 184.108.40.206.228, but cannot find any evidence in favor of or against this conclusion.
Thank you. Yes, I would have liked to be able to enable/disable each port, set it up as a trunk/access/routed port, and set the access VLAN. Configuration of the authentication method is not a priority at the moment. What seemed strange to me is that, besides the case of being managed by a controller, even in standalone mode the H510 provides a web interface to configure the ports under consideration.