How to configure Ruckus R610 after LACP

[quoc_viet_tran]

Currently, the controller and AP web UIs do not expose LACP settings or configuration. If an AP is configured via AP CLI to bond its Ethernet ports, then any per-Ethernet port setting in the web UIs are ignored by the AP.

So, how can configure Ruckus R610  after Configure LACP ?

[sunny_gupta]

Hello there, this must be configured via CLI.  Here are the commands.

CLI Config commands

Log in to AP CLI using SSH
- Bond command on the CLI can be used to configure LACP.

Command format as below.

get bond - Show Bond Info
set bond {options} - Configure Bond/LACP settings
** <profile>: bond0, ...
** options: enable : R720 Only to enable LACP Mode
disable : R720 Only to disable LACP Mode
lacp-rate [0,1], 0 for slow, 1 for fast
xmit-hash [0,1,2], 0 for L(ayer2), 1 for L3+4, 2 for L2+3
{add|delete} <eth0| eth1>
 
Example: 
Set bond bond0 add eth0
set bond bond0 add eth1

Get bond

Please see KB for more details:

https://support.ruckuswireless.com/articles/000009914

[quoc_viet_tran]

@sandeep_gupta_89lya7d7doyxy 

Hi, after add eth0, eth1 to bond 0, I can't config throuh WebUI. How can I config my AP after configured LACP ?

Thanks

[sunny_gupta]

Hello, I'm not sure I understand.

LACP configuration is via CLI only, you cannot see or make changes from GUI.  What change are you trying to make after enabling LACP?

Also I just tried this and you simply need to run the command:

set bond bond0 enable

get bond --> to confirm the status