I have three R310 Unleashed access points in a mesh network. I want to broadcast two SSIDs -- one for departmental traffic and one for guests, each with its own VLAN. I originally had the ports set up as access ports and my primary SSID was working and I could configure my system through the web interface. To achieve my goal of two SSIDs on separate VLANs I configured the ports on my Cisco C3750 routers as 802.1q trunk ports and allowed VLANs 1,30 and 60 and designated 1 as the Native VLAN. 30 is for the department SSID and 60 is for Guests. I set the Access IP on the departmental SSID to 30, and have not yet configured the Guest VLAN. I was tested my departmental network and got good connections -- all APs were broadcasting properly Here's the rub -- when I went back to my desk I could no longer access my AP through the web interface. I also cannot ping it. When I set the port on the switch back to static access, I can ping the AP but still can not access it through the web interface. What could cause this?