Additional unleashed mesh AP shows as "Configure.Me" after powered up, Why?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-03-2017 06:07 AM
2 wired (master\reserve) and 3 mesh.
Today I added a 6th AP.
Dashboard AP settings are "join automatically when discovered"
The 6th AP still shows as "Configure.Me" SSID 45 minutes after powering up.
The same thing happened with the 5th AP but suddenly one day, after powering up\down\trying wire it suddenly started working.
This would not be an issue trying on this AP if it werent for it being mounted on top of a flagpole and therefor is hard to access physically.
I can access the main wifi with 2 bars from AP 6' location so it should be able to connect to it.
When adding new mesh AP, do I need to connect it with wire first before I "mesh" it ?
Because I have not done that in this case.
Can I still hope for it to come online\join the mesh or should I just start taking it down again to do a factory reset?
Thanks for any tips\help
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-13-2020 08:52 AM
I did exactly that. Except the reboot. This one happened while moving away from the switch to the wall !
It got configured and was working in mesh (AIR led on). Only powered (POE but without any LAN connected) with a POE adapter.
That's why I suppose there is a "save the settings" somewhere in the console which was not checked... 😞

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-13-2020 09:03 AM
I've never done mesh with a PoE injector.... I wonder if the WAP is confused and doesn't switch to mesh. I've always done local power adaptor. That's a good test for me to try. Do you have a power adaptor?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-16-2020 11:54 AM
The only connection is ethernet. So POE is mandatory.
BTW
The AP ended up in mesh and working.
It looks like the AP searches for any accessible controller and if accepted by the controller it gets provisionned.
I left it unconfigured and it was ok when I checked 2 days after.
I don't have any other AP to set up.
No more issue.
Thanks you.

