HI.
I tested a failover and takeover of unleashed aps.
However, it did not meet our expectations.
In my lab, I deployed two ap; a H510 and a H320;, and configured static ip address on each.
I did master setup to H510 and member setup to H320.
Once I confirmed all aps were good working, went down power to all APs.
And I was turned on H320 which was member ap before a reboot.
But election of new master didn't occur.
The H320 which was member ap before a reboot became new master for about 20min.
Why is the new election process so slow?
If this situation was a real, customer would have many complaints becasue he thought a network problem.
Are Ruckus aware of this?
Regards.
