cancel
Showing results for 
Search instead for 
Did you mean: 

RF POLLUTION ?

prabakaran_b
New Contributor III
What is RF pollution in the Performance graphs(T301s)?  If RF value is above 150 or 200 how could it impact to connected clients. Required suggestion to reduce RF value as normal.
4 REPLIES 4

michael_brado
Esteemed Contributor II
Hello Prabakaran,

    Do you run the T301s in Solo/Standalone mode, or is it managed by a ZD or SZ controller?
Please tell me where to find the Performance graph you're discussing and I'll look into it further.
I believe RF Pollution is representative of local Noise Floor, or the level where the AP's PHY can
no longer interpret real client RF signal OFDM headers at Layer1.  To reduce, analyze what is
around your AP that gives off EMF or alternate RF signals, and try to locate your AP as far away
as you can or try to shield your AP from them.

prabakaran_b
New Contributor III
Thx Mr.Michael,

     Actually T301s managed by ZD where we seen RF performance graph,Let us know the normal value of RF pollution and we facing all clients (25 clients) are getting latency ,drop issue.Find snap here.


Image_ images_messages_5f91c43b135b77e2479d32b3_d0ab8597aa23c0a9ab71efcc566d9611_RackMultipart2017081872963w3my-b8da80de-024e-4953-a2f8-3de3bcd7442f-1788354178.JPG1503033462Image_ images_messages_5f91c43b135b77e2479d32b3_7042ead577ec6abec8885b40d8647662_RackMultipart2017081872963l02r-787af9d4-67d7-4fe1-96e4-5230883cf08d-781508388.JPG1503033554

prabakaran_b
New Contributor III
Pls update above query

michael_brado
Esteemed Contributor II
To determine the normal RF "pollution/interference" is dependent upon your environment.

Do you see similar for APs in different areas?

Can you identify any possible RF interfering devices located near to this AP?  Things like Heating/AC vents,
florescent light ballasts, emergency backup lights, anything mechanical, elevators, other WiFi equipment, etc?