ICX 7250 08.0.91T211 boots as Non-UFI

[network_adminis]

Using SmartZone updated two stacks one stack was successful the other not.
Updated from 08.0.90bT211 to 08.0.91T211 unit 2 was still up and unit 1 kept rebooting because of software not sync'ed over and over. Unit 1 was showing 08.0.91T211 Non-UFI and unit 2 was showing 08.0.91T211 UFI.
Unconfigured stack on unit 1 and then manually load firmware then is showed UFI but kept rebooting because Unit 2 said it was out of sync.
Disconnected Unit 1 from unit 2 manually uploaded firmware to unit 2 and reloaded. 

Stack was happy, is this normal?
Ran 08.0.30 for 2 years no problems 

[hashim_bharooc1]

Hi Network Administrator,
You need to step upgrade first to 8080e code, this code allows you to do a non UFI to UFI Upgrade.


Hope this helps.

Thanks
Hashim

[network_adminis]

Updated from 08.0.90bT211 to 08.0.91T211 why go backwards to 0880e?

[hashim_bharooc1]

I was stating for future upgrades, not for this one.

I was trying to explain the reason why you ran into issues. 

You did not step upgrade via 8080e code so you ran into this issue.

[network_adminis]

I was already on 08.0.90bT211 UFI pushed 08.0.91T211 UFI (which is ONLY UFI) and the switch was reporting 08.0.91T211 Non-UFI (not possible because there is NO Non-UFI 08.0.91T211)