cancel
Showing results for 
Search instead for 
Did you mean: 

New firmware, old bootrom

sinisa_babic
New Contributor II

Hello,

I did an upgrade ICX7150 to SPS08095e to a few switches but the old bootrom remained on some of them.

telnet@ICX7150#show flash
Stack unit 1:
  NAND Type: Micron NAND 2GiB (x 1)
  Compressed Pri Code size = 31457280, Version:08.0.95eT211 (SPS08095e.bin)
  Compressed Sec Code size = 31457280, Version:08.0.95eT211 (SPS08095e.bin)
  Compressed Pri Boot Code size = 786944, Version:10.1.14T225 (mnz10114)
  Compressed Sec Boot Code size = 786944, Version:10.1.21T225 (mnz10121)
 

Any idea how to solve this?

1 ACCEPTED SOLUTION

BenBeck
Moderator
Moderator

Hey There, 

Are you seeing a bootrom mismatch? 'show version' and 'show boot-monitor' should tell you. The boot code is included in the UFI image. If you are seeing any kind of mismatch, just go ahead and re-copy the UFI image to the appropriate partition (pri/sec) and it should get updated. 

Ben Beck, RCNA, Principal Technical Support Engineer
support.ruckuswireless.com/contact-us

View solution in original post

4 REPLIES 4

mohammad_atmazi
New Contributor III

it's a UFI image no Bootrom is needed

sinisa_babic
New Contributor II

Thank you for response.

BenBeck
Moderator
Moderator

Hey There, 

Are you seeing a bootrom mismatch? 'show version' and 'show boot-monitor' should tell you. The boot code is included in the UFI image. If you are seeing any kind of mismatch, just go ahead and re-copy the UFI image to the appropriate partition (pri/sec) and it should get updated. 

Ben Beck, RCNA, Principal Technical Support Engineer
support.ruckuswireless.com/contact-us

@ben_beck

I did that and now is ok, there is no mismatch anymore. Thanks.