Dear Ruckus,
My client requested to configure some access Point in Mesh mode
This was his initial request:
"APs to be configured mesh mode as follows (connected via PoE for configuration):
Ruckus R510 / MAC e81da8159d04 / SW03 port19"
But when I access that Switch 03 and search for this mac-address.
I did not find any AP anywhere in the switch
SW03# show mac-addr e81da8-159d04
Status and Counters - Address Table - e81da8-159d04
Port VLAN
----- ----
_______________________________________________________________________________
Please can some guide, how can i configure the AP in mesh mode.
we have Ruckus SmartZone 100
To configured the AP in mesh mode, Shouldn't the AP 1st be visible in the Switch ?
