How to configure AP in mesh mode

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

Dear Ruckus,
My client requested to configure some access Point in Mesh mode

This was his initial request:

"APs to be configured mesh mode as follows (connected via PoE for configuration):

Ruckus R510 / MAC e81da8159d04 / SW03 port19"

But when I access that Switch 03 and search for this mac-address.
I did not find any AP anywhere in the switch

SW03# show mac-addr e81da8-159d04

Status and Counters - Address Table - e81da8-159d04

Port VLAN
----- ----

_______________________________________________________________________________

Please can some guide, how can i configure the AP in mesh mode.
we have Ruckus SmartZone 100

To configured the AP in mesh mode, Shouldn't the AP 1st be visible in the Switch ?

0 REPLIES 0