Showing results for 
Search instead for 
Did you mean: 

Ability to configure prior to deployment

New Contributor II
Is there any way to configure that Virtual SmartZone prior to deployment? I'm looking to arrange my setup into an infrastructure as code type deployment but the initial start is a really bogged down process. It really should be as simple as defining the software and setting some environmental variables (Profile and IP/Netmask/Gateway). At present, unless I'm not doing something correctly I have to deploy to very specific virtual environments, go through and interactive set up process via CLI and then afterwards also another interactive process within the web interface. That is the stage I'd like to be up to on my deployment from the get go with the ability to control parameters from a config file or something. Is this something I can achieve with the vSZ?