Username and password for Lennar ICX 7150

[Evidal92]

Recent changed to a new internet provider, when trying to update the ICX switch, I logged out by accident. Have not been able to log back into the switch, and tried all of the Kenna user name and passwords with no luck. Any help will be appreciated. 

thanks 

[Vásquez_Fer]

Hi @Evidal92 

Hope you are doing well ! 

If you are Lennar home user you can try all these password listed on the below link 

Admin usernames and passwords for the Ruckus Wi-Fi Access Points/Switch for Lennar home users

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Admin-usernames-and-password...

If these passwords and usernames do not work we need to access via Console ( physical connection ) 

The first step is to console the ICX 7150-C12P using the USB to USB type C or Rj45 to USB

Here is a short guide how to do it  step by step : 

How to console in the ICX-7150-C12P

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-console-in-the-ICX-71...

The second step is to press some keys and write some commands : 

1.Start a CLI session over the serial ( console access) interface to the RUCKUS ICX device.

2-Enter OS mode. This uses a key combination and drops below the fastiron operating system

Key Combination: Ctrl+y, release, tap 'm', tap 'Enter'

OS>

4-just write reset

OS>reset

5-.While the system is booting, before the initial system prompt appears,
enter b to enter the boot monitor mode.

Enter 'b' to stop at boot monitor: 0

In this Part you have to press B before the counter ends

6-Enter no password. (You cannot abbreviate this command.)

ICX7650-Boot> no password
00 00 00 00
OK! Skip password check when the system is up.

7-Enter boot. This command causes the device to bypass the system password
check.

ICX7650-Boot> boot

8-After the console prompt reappears, assign a new password.

Here is a short video that explains all the steps : 

https://www.youtube.com/watch?v=XJS28DWbHM4&t=114s

Best Regards 

Fernando Vasquez