Unleashed App

[bdspecht]

I bought a Lennar home and am trying to figure out how I connect to my switch and access points using the Unleashed App, when I go in it asks for a Typical Install or Gateway Install, I choose Typical and it says power on the AP which I did, them it says set your mobile wifi to Configure.Me-xxxxxx, when I check wifi on my phone I do not see Configure.Me-xxxxxx. Can you tell me why?

[bdspecht]

Thank You, I will try this and get back to you

[Imran_ruckus]

Hi @bdspecht 

Greetings!!!

Thank you for the response and the information.

Sure, please let me know if you need any assistance in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[bdspecht]

I was able to configure using a laptop, now that I have it setup do I have to do anything for my second access point or do I just reconnect it and it should work as well?

[bdspecht]

I found my answer

8 ) Once the process it's finished, connect back to the Ruckus Switch the access points that you disconnected before, and they will connect into the network automatically after a few minutes.

Thanks for your help!

[Imran_ruckus]

Hi @bdspecht 

Greetings!!!

Thank you for the response and update.

Great!!! Good to know that you have completed factory reset process.

NOTE: Please feel free to mark the factory reset post as ACCEPTED SOLUTIONS.

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.