Switch in boot mode after power outage

[nimittsarda]

We had a power outage recently after which the AP points do not boot up. I connected my laptop to the Ruckus ICX 7150-C12P Switch via putty but the switch remains in "boot" mode. I tried booting from primary and secondary partition but for both it says corrupted.

So I followed instruction in this link to try and install new image, however now I am stuck at "host 192.168.0.2 is not alive" I set all the required environment variables (as can be seen from the snip below). Please help!

printenv
baudrate=9600
ipaddr=192.168.0.3
serverip=192.168.0.2
netmask=255.255.255.0
gatewayip=192.168.0.2
uboot=mnz10115.bin
image_name=SPR08090d.bin
ver=10.1.15T225 (Jan 30 2019 - 23:08:47 -0800)

Environment size: 189/16379 bytes
ICX7150-Boot>ping 192.168.0.2
Change GMAC speed to 1000MB
Using bcm_xgs_gmac-0 device
ping failed; host 192.168.0.2 is not alive
ICX7150-Boot>

[fan_the_man]

Hello, 

I had the same exactly issue. How can I get a replacement?

Thanks, 

Fan

[Imran_ruckus]

Hi @fan_the_man 

Greetings!!!

Thank you for contacting Lennar Home Community.

Hope you are doing well

As this case is raised by @nimittsarda which is now resolved.

To avoid confusion with posts, you can create your own post with the problem you're facing and a detailed description of the network issue and what you've done so that we can guide you properly.

Thank you again for understanding.

Best regards,

Imran Sanadi

Lennar Home Community.