Stuck

[Cjessee]

Tried resetting the ruckus 7150 and stuck still. Tried to reset with software and would not work.  

[pinky_ruckus]

Hi @Cjessee ,

Thank you for the response.

From the response shared, I understand that the status lights on the Switch is Amber and the PWR light is Green which means that the Switch is stuck in the boot mode.

Please follow the below RUCKUS Lennar Knowledge base self-help article which will help you to fix the issue when the Switch is in boot mode.

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/Fixing-RUCKUS-Switch-with-an...

Please follow the process as explained in the article and let me know if you have any queries in this regard. 

Thank you again for your patience and understanding.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.

[Cjessee]

Hello thanks for the reply. I have tried the hard reset. The lights have been flashing between amber off and on since the reset. I have followed the forum and also tried a software instructions on the forum but that did not work. The ruckus 7150 we have I believe is faulty. Please help me with starting and RMA and replacement. 

Thank you 

[pinky_ruckus]

Hello @Cjessee ,

Thank you for the response.

I understand that you are getting stuck while performing the software recovery.

I would request you to please share the cable connection between the Switch and the laptop while performing software recovery. (Please see the below picture as reference)

Also, please share the screenshot of the COM port details. COM port details should be with the silicon lab name in the device manager.

I would request you to please check if both the drivers are installed as per the software recovery article.

 

Once again, please make sure to download the zip drive for the file below & "extract all". Once it's extracted, run the file, the driver should be installed using the 2 links below.

Link 1: https://support.ruckuswireless.com/software/1414-brocade-ruckus-7150-usb-serial-driver-windows

 

Link 2: silabs.com/developers/usb-to-uart-bridge-vcp-drivers?tab=downloads

Could you please restart the laptop after installing the drivers and check the COM port details in the Device Manger from the Control Panel?

Also, please wait for few minutes and check if boot> prompt is visible.

Please let us know if you have any queries in this regard.

Thank you for your patience and understanding.

Regards,

Pinky Rajendran

RUCKUS Lennar Home Community

[Cjessee]

 putty says ICX7150-Boot> after connecting 

[Cjessee]