Ruckus ICX7150 Switch is missing from the "show flash" command

[NV]

A storm caused a power outage which then caused my Ruckus to change from SPS08090d to SPR08090d.  I followed some of the information showing how to correct it and it wouldn't go back to SPS08090d.  I did a factory reset after that and now it shows both primary and secondary are SPR08090d, there is no option for the switch version now.  Is there anything I can do to add SPS08090d back as a primary and make it work?

[Jayavidhya]

Hi @NV

To perform SPS08090d as primary or secondary, you can perform an upgrade by following one of the below steps:

1.Upgrade a Switch ICX-7150-C12P using a USB flash drive

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

2. Upgrade a Switch ICX7150-C12P via TFTP

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

3. Upgrade a switch via Web GUI (ICX7150 Switch)

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-an-Upgrade-vi...

Best regards,

Jayavidhya

Lennar Home Community

[Jayavidhya]

Hi @NV

To perform SPS08090d as primary or secondary, you can perform an upgrade by following one of the below steps:

1.Upgrade a Switch ICX-7150-C12P using a USB flash drive

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

2. Upgrade a Switch ICX7150-C12P via TFTP

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

3. Upgrade a switch via Web GUI (ICX7150 Switch)

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-an-Upgrade-vi...

Best regards,

Jayavidhya

Lennar Home Community