1 ACCEPTED SOLUTION
Hi @MrAntCali48
Greetings!!!
Thank you for the response and the update.
Yes, I can see from the pictures shared, earlier your Switch was booted up on the secondary partition which is on SPR (Routing Code) and now you have your Switch booted up on the Primary partition which is on SPS (Switching Code). It must be on the SPS code for Lennar Home users.
Earlier:
Now:
To avoid this issue in the future please execute the below commands on the CLI to bring your Switch Secondary partition also on the SPS code. In case your Switch boots up on the secondary partition in the future due to power outage/power spikes there won’t be any such issues.
Note: Hit Enter to accept each command
enable
show version
copy flash flash secondary
boot system flash secondary yes
Example:
VIDEO LINK AS REFERENCE: https://www.youtube.com/watch?v=Eem1IBgYaWc
ICX7150-24P Router>enable (hit enter to accept the command)
ICX7150-24P Router#copy flash flash secondary (hit enter to accept the command and wait: until the flash finished)
ICX7150-24P Router#boot system flash secondary yes (hit enter to accept the command: the switch will reboot)
Please let me know if you have any queries in this regard.
NOTE: Please feel free to mark the post as ACCEPTED SOLUTIONS.
Thank you again for your patience and understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
Hi @MrAntCali48
Thank you for the response.
Please try to access CLI using the telnet option as shown in the below screenshot.
Telnet – Port 23
Please let me know if you have any queries in this regard.
Thank you again for your patience.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
Hi @MrAntCali48
Greetings!!!
Thank you for the response.
Apologies, RUCKUS does not have any support team of technicians to support on-site for Lennar Homes.
As this is a simple issue, when you are getting the below error, please try to access Switch CLI via the Telnet option as described in my previous post.
Please do let us know if there is any help required on the troubleshooting steps or if you are stuck at any point. We are happy to help you.
Thank you again for your patience and understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
Cannot get pass this screen and when I do I cannot get pass the frozen password part
Hi @MrAntCali48
Thank you for the response.
Please try to access via the TELNET option as described previously (also sharing it below once again). Telnet does not require any password.
Please try to access CLI using the TELNET option as shown in the below screenshot.
Telnet – Port 23
Please let me know if you have any queries in this regard.
Thank you again for your patience.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
