ICX-7150-C12P takes multiple attempts to boot or reset in in switch console

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

When my switch loses power for any reason it will fail to boot on it's own. I have attempted the hard reset by pressing and holding the reset button while applying power to the switch, however it doesn't appear to take. If I console into the switch and run the boot command then I'll mostly see the following error with the Primary and Secondary images:

BOOTING image from Primary

NAND read: device 0 offset 0x0, size 0x2000000
3 ecc_errors after reading 1aea000:1aebc00
iproc_nand_read_page returned 2
NAND read from offset 0 failed -22
0 bytes read: ERROR
## Loading kernel from FIT Image at 70000200 ...
Bad FIT kernel image format!
ERROR: can't get kernel image!

If I run the boot command more than a dozen times or do a reset command on console then eventually the image will load and bring functions online. I have to do this every time when the switch lost power and it's very frustrating at time. The switch is currently running firmware version SPS08090d. Is this problem indicative of a hardware failure? If so, how can I invoke the warranty?

3 REPLIES 3