How do I check to see if I need an upgrade to my ICX 7150-c12p needs to be updated?

[Optiplex_175941]

I have downloaded Putty and TFTpd64. I am not sure how to check my switch to see if it needs to be upgraded, and then if it does need to be upgraded how to do it with those 2 software programs.

[Imran_ruckus]

Hi @Optiplex_175941 
Greetings!!!

Thank you for contacting the RUCKUS Community forums.

Could you please let me know if this is a Lennar Home RUCKUS setup?

Please confirm.

Thank you again.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[Optiplex_175941]

It is a Lennar home set up. It is a new switch out of the box as well. Thank you for the help. 

[Imran_ruckus]

Hi @Optiplex_175941 

Greetings!!!

Thank you for reaching out to the RUCKUS Lennar Home Community. 

We appreciate your patience and understanding as we work to resolve the issues you are experiencing with your RUCKUS setup.

Based on the information provided, it appears that you need assistance in Upgrading your RUCKUS ICX-7150-C12P Switch.

We may need to check the current version that is running on your Switch to assist you accordingly.

To proceed with the same, please follow the steps outlined below to access the Command Line Interface (CLI) and provide the necessary command outputs:

1. First, identify the current IP address assigned to the switch ICX-7150-C12P by your local router. You can use an IP scanner tool to easily locate the switch's IP address on your network. Here is a guide on how to perform this using IP Scanner free applications: 

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-find-the-IP-Address-o...

2. Once you have identified the IP address of the switch, proceed to access the Command Line Interface (CLI) of the RUCKUS ICX-7150-C12P switch. Here is a guide on how to access the CLI: 

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-access-the-Command-Li...

If you can access the Command line the prompt should look like below:

ICX7150-C12 Router> OR

ICX7150-C12 Switch>

3. After successfully accessing the CLI, please execute the following commands and provide the outputs:

   enable

   show version

   show flash

   show inline power

   show inline power detail

   show interface brief

Please share the command outputs or screenshots if you encounter any issues or errors during these steps. 

Feel free to reach out if you have any questions or require further assistance.

Thank you for your cooperation and patience.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community