RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.
You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.
Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.
01-16-2024 08:16 AM
I just upgraded to google fiber and am currently running a Netgear Nighthawk as the router. I am only getting 300mbps down and up. From looking at the specs the 510 AP should be able to handle 867 Mbps up. Is there a recommended router that works better with Ruckus? When wiring everything in to the ICX 7150 is there a particular port that the internet should come in on? I currently have the AP's in the first 3 ports. Thanks for any help.
01-16-2024 08:41 AM
Hi @pir8sfan
Greetings!!!
Thank you for contacting RUCKUS Community forums.
Could you please let me know if this is a Lennar Home RUCKUS setup?
Please confirm.
Thank you again.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
01-16-2024 09:04 AM
Yes this is a Lennar home.
01-16-2024 09:30 AM
Hi @pir8sfan
Greetings!!!
Thank you for contacting RUCKUS Lennar Home Community.
I hope you are doing well!!!
Thank you for the information you shared.
As per the case description, I understand that you need assistance in setting up RUCKUS devices.
Yes, the RUCKUS ICX-7150-C12P Switch works with any Router/Modem-Router combo devices for higher speeds.
You must plug Router/Modem-Router’s or any device's ethernet plugs into any 1 in-12 ports of the RUCKUS ICX-7150-C12P Switch as described in the below guides.
Please refer to the short guide link below about how to connect the devices as a reference:
Most common Setups for Lennar homes users:


Please check and let me know if you have any queries in this regard.
Thank you again for your patience.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
01-16-2024 09:43 AM
Thta is helpful, is there a setting that needs to be adjusted to make sure direct wire is getting the gigabit speed? I tested directly at the port on my third floor plugged into the ICX7150 port number 8 and I am only getting 98MBPS down even though in the same room through wireless I am getting 300MBPS down.
