Cannot open a port on Ruckus Switch

[gravityrahul]

Hello:

Couple of issues. 

1. My previous switch won't come up due to outage and I have a new switch. 
   I was able to login to my 7150-C12. However is it showing router. I guess that is fine?
2. Secondly, I am unable to open the ports and the access point in my first floor and second floor doesn't propagate any signal. 
3. Even though the LEDs are green on 2.4G, when I connect my device there is no connection. 
4. Also, I have an ethernet cable connected from Ruckus switch doesn't provide connection. 
5. Finally, I am unable to connect to https://unleashed.ruckuswireless.com
6. Even though I am connected to my VPN.I also tried to connect via Model directly via ethernet cable but still cannot connect to unleashed. 
7. Finally this is my front panel 1/1/2 and 1/1/7 are connected to ethernet ports (not active). Front panel
8.  
9. Login Prompt
10.  
11. Ethernet Statistics
12.  
13. 
14.  
15. Switch
16.  
17. Level 1
18.  
19. Level 2

[gravityrahul]

Hello Imran

I am using the same username and password as the web switch GUI. Is there a way to upgrade using switch GUI?

Also, I am not sure if my last two steps in terminal is even working ? As per the instruction, after the RSA is created, the username and password is set. However in my case I see the same username and password being printed back onto the terminal (which I don't know is expected or not)

Similarly, aaa autherntication login default  local is printed back to the terminal. Not sure if that is executed?

Thanks

InstructionMy Prompt

[Imran_ruckus]

Hi @gravityrahul 

Greetings!!!

Thank you for the response and the detailed information.

Could you please refer to the below article on upgrading the RUCKUS ICX-7150-C12P Switch using web GUI and try to upgrade?

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-an-Upgrade-vi...

Please let me know how it goes.

Thank you again. We appreciate your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[gravityrahul]

Hello Imran

I am unable to open tftp on RUCKUS switch CLI. The tutorial is not working as I have a Mac and can't open putty TFTP

How can I transfer this file SPS08090kufi.bin from my Downloads folder to Ruckus Swicth Primary partition?

[gravityrahul]

Hello Imran

I am able to down and install SPS08095g.bin in Primary partition but still can't get any internet in ports using cable, nor my Ruckus APs have signal. 

[Imran_ruckus]

Hi @gravityrahul 

Greetings!!!
Thank you for the response and the update.

Could you please share the current output of the commands mentioned below after the upgrade?

Please execute the following commands in CLI and provide the outputs:

   enable

   show version

   show flash

   show inline power

   show inline power detail

   show interface brief

Please share the command outputs or screenshots if you encounter any issues or errors during these steps. 

Feel free to reach out if you have any questions or require further assistance.

Thank you for your cooperation and patience.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community