After ICX 7150 c12p factory reset need help assigning Ip address and basically setting everything

[mpyrtle]

I had to repost because it wasn’t in the Lennar forums I was told. Yes this is for a Lennar smart home.

Hello. I had to reset my ICX switch to factory and now I need a walk through to set everything back up.

I am able to get to the switch via the command line with USB-C to from the switch to my laptop. I was able to create a new password after the reset but I really don’t understand or know the commands like that to assign the IP address, default gateway, and TFtp. I have download putty and TFTP but as of now I’m stuck on assigning a IP address to the TFTP on the switch. 

The commands I found on the forums seems to not work when trying to assign IP address. I just need a up to date or someone to speak to help assist getting the switch not the AP back functioning from the Lennar setup please..

[Imran_ruckus]

Hi @mpyrtle 

Thank you for the response.

As you are using the wrong bootrom file, please use mnz10114.bin.

Your Upgrade folder should contain these 3 files shown in the below screenshot: (Refer the guide link for more information)

Please check and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[mpyrtle]

@imran_ruckus @sgatjens

Ok I'll try that and let you know.

The instructions does say use what I had before:

I got the same error:

[Imran_ruckus]

Hi @mpyrtle 

Greetings!!!

Thank you for the response and the update.

Please try to select other IP addresses from the 'Server Interfaces' in the TFTP server application and perform using the selected IP address in the CLI command. (Please refer to the below screenshot)

Please check and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[mpyrtle · Accepted solution]

@imran_ruckus @sgatjens

Same issue. I change the IP address to match the IP within CLI.