Ruckus R750

[AriG]

Hi

I am new to admining Ruckus Cloud R1.

I need to configure and install an AP. I have a Ruckus R750 with Version 6.0.0.1.3209. it has been offline for some time.

When I try to configure it in Ruckus, I see the message

"never contacted cloud "

Venue Firmware Version: 6.2.1.103.2579

I suspect it may need a firmware update however I wanted to check first.

regards

[syamantakomer]

Hello @AriG,

SZ AP firmware are usually compatible for RUCKUS-One onboarding.

Since it is not working for you, please verify below points and see if that helps.

1. Make sure AP is not in connected state to another controller. You can check this by login into the AP CLI and run the command "get scg".
2. Make sure AP is able to reach internet and all the important public URL are reachable, you can find the list of port and URLs on RUCKUS-One UI.
   

3. If everything is looking good and still AP is not connecting, upgrade the AP firmware to standalone version. You can download the image from here.

[AriG]

Hi

How do I login into the AP ?

[Amith]

Hi @AriG, 

Please perform a hard reset on the AP and try to login using the default credentials: super/sp-admin.

Steps to perform a hard reset:

 -> On the rear side of the AP you can see the "HARD RESET" hole which is located near the Ethernet ports.
-> Insert a paper clip or any point object into the “HARD RESET” hole and press & hold it for 15-20 seconds.
-> This factory defaults the AP.
-> Now the AP can be accessed using it's default ip address 192.168.0.1 by directly connecting to a PC in the same subnet.
Execute the commands: "get acx", "get version" and "get scg" from the AP CLI. 

Note: Once the AP gets connected to the cloud portal you will not be able to login to the AP. Only Ruckus support has access to the CLI. 

Thank you!
Amith 

[AriG]

Hey dhanyavad Syamantaka

https://www.192-168-1-1-ip.co/router/ruckus-wireless/r750/24863/