How can i enable SNMP for the APs in the Cloudcontroller?

[dennis_stormer]

I have to enable SNMP for the APs in our Cloud Controller, but i cant find the Setting for this. Ping is working, but SNMP request not, so i think its disabled. Since the Firmware 200.1.9.12.62 MR SNMP is supported for Unleashed APs, so it should work.

Someone who can help me?

Regards Dennis

[jamesrucker]

I guess we can't! thanks! 

[syamantakomer]

Hi @jamesrucker,

Refer the reply in the same thread. SNMP is supported on RUCKUS-One (previously known as RUCKUS Cloud). If your account is still running on RUCKUS Cloud, please open a support case and Support will help for early migration.

https://community.ruckuswireless.com/t5/RUCKUS-Cloud/How-can-i-enable-SNMP-for-the-APs-in-the-Cloudc... 

[renzo_carpio]

Thank you for your prompt answer!

[vasanth_edward · Accepted solution]

Hi @renzo_carpio, @jamesrucker,

Thank you for writing to RUCKUS Support via FORUM.

SNMP can be enabled from RUCKUS ONE now. However, APs support SNMPv2 and SNMPv3 in read-only operation.

Please refer User Guide https://support.ruckuswireless.com/documents/4481-ruckus-one-online-help-user-guide page 549 & 551 to configure SNMP agent profile & page 210 for enabling in individual AP.

MIB files can be download from https://support.ruckuswireless.com/software/3303-smartzone-6-1-0-0-935-ga-snmp-mibs-for-access-point...

For SNMP OID refer SNMP reference guide, can be downloaded from https://support.ruckuswireless.com/documents/4373-smartzone-6-1-1-lt-ga-snmp-reference-guide-sz100-v...

Do let us know should you have any further queries.

Regards,

Vasanth Edward

[Rucky860]

From the SNMP reference guide I'm not seeing that traps related to clients are supported? Specifically, I was looking for something similar to ruckusZDEventClientJoin and ruckusZDEventClientDisconnect traps.