switch

[A_jos]

how i can change the firmware for a switch Ruckus icx 7150-24?

[Imran_ruckus]

Hi @A_jos 
Greetings!!!

Thank you for contacting the RUCKUS Community forums.

Could you please let me know if this is a Lennar Home RUCKUS setup?

Please confirm.

Thank you again.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[A_jos]

idk i think

[Imran_ruckus]

Hi @A_jos 

Thank you for the response.

One of our ICX engineers will post answers to your queries on this case.

For now, I understand that you have a Switch of ICX7150-2P and you would like to upgrade to the next stable version.
So the recommended firmware for ICX7150 is 08.0.95m.

You can refer to the below link for your reference:

https://www.youtube.com/watch?v=DHIEajPhHWQ&t=268s

https://support.ruckuswireless.com/software?filter=108#sort=relevancy&f:@commonproducts=[ICX%207150]

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-upgrade-RUCKUS-ICX-71...

(From the above link, please ignore the versions and you can upgrade to the 08.0.95m version)

Moving Forward If this issue is not resolved, Please log a ticket with the below link so that we can help you further.

https://support.ruckuswireless.com/contact-us

I hope this information helps you

Please feel free to leave us a message if any concerns.

Thank you again for your 

[Mayank]

Hi A_jos,

Thank you for reaching us.

Please feel free to run "show version" on the switch. Here I am taking the example of the 7150 switch to explain.

If the code is "SPS" it would be a switch code and if the code is "SPR" it would be a router code.

S - Switch

R - Router

Run the below command :

show flash

From the above command, you can confirm the code in the flash of the ICX switch code or router code and from the show version command you can confirm from which code you are booting.

If for example you want  the router code and it is in a primary flash you can run the below command :

boot system flash primary

If for example you want  the switch code and it is in secondary you can run the below command :

boot system flash secondary

Note: Please run the above command after putting write mem in the maintenance window.

You can also refer to the below link for your ref:

https://docs.ruckuswireless.com/fastiron/08.0.60/fastiron-08060-commandref/GUID-9B008914-403A-4FE1-8...

Please let us know how it goes.

Moving Forward If this issue is not resolved, Please log a ticket with the below link so that we can help you further

https://support.ruckuswireless.com/contact-us

I hope this information helps you

Please feel free to leave us a message if any concerns

Note: Please feel free to mark the post as ACCEPTED SOLUTIONS if it addresses your query.

Thanks