cancel
Showing results for 
Search instead for 
Did you mean: 

switch

A_jos
New Contributor

how i can change the firmware for a switch Ruckus icx 7150-24?

5 REPLIES 5

Chandini
RUCKUS Team Member

Hi A_jos

Thank you for reaching us. 

Adding to the post. When you run "Show version" you would see output as below

ICX7850-48C Router#show version
Copyright (c) Ruckus Networks, Inc. All rights reserved.
UNIT 1: compiled on Jan 12 2024 at 10:03:57 labeled as TNR09010j
(69659728 bytes) from Primary TNR09010j.bin (UFI)
SW: Version 09.0.10jT233
Compressed Primary Boot Code size = 1573376, Version:10.1.26T235 (tnu10126)
Compiled on Tue Nov 29 12:43:36 2022

When you run "show flash" you would see below output

ICX7850-48C Router#show flash
Stack unit 1:
Compressed Pri Code size = 69659728, Version:09.0.10jT233 (TNR09010j.bin)
Compressed Sec Code size = 69659728, Version:09.0.10jT233 (TNS09010j.bin)
Compressed Pri Boot Code size = 1573376, Version:10.1.26T235 (tnu10126)
Compressed Sec Boot Code size = 1573376, Version:10.1.26T235 (tnu10126)
Code Flash Free Space = 2460647424

If the switch is running in router code and in flash if you have a switch code running in either flash then you can use command "boot system flash <primary/secondary>" to reboot the switch from that flash. 

For example in above example I have a switch code TNS09010j in my secondary flash so I can use "boot system flash secondary" to boot my switch from secondary flash which runs switch code. 

If both secondary and primary are in router code then you might have to upgrade the switch to a switch code. You can refer the below links which will help you with upgrade process. 

Thanks