cancel
Showing results for 
Search instead for 
Did you mean: 

how to set default secondary Flash image

bharat_gole
New Contributor III

Hi, 

we are using ICX7150 switch for router feature, therefor i had use the below command for using secondary image and reload the switch in the secondary image. but, while i reboot the switch, its up by primary image only.

# boot system flash Secondary yes

Can you please help me to tell us how to set default secondary Flash image.
6 REPLIES 6

vincent_felisaz
Contributor

Hi Bharat

just put in the config like that :

# configure terminal

(conf)# boot system flash secondary

save your configuration

(conf)# write mem

that's it

Cheers

Vince

thanks a lot Vincent

its done.

Hi Bharat,

Please make note that going forward with 8090x code, we recommend having same code on both primary and secondary flash, this is a new limitation with the 8090x code.

Hope this helps.

Thanks

Hashim

Thanks

Hashim

Hello,

just to clarify, starting 8.0.80 there is the introduction of Unified FastIron Image (UFI). This is recommended to have both flash with UFI images but not necessary the same type (Switching/Routing) or release.

No limitation here.

Cheers

Vince