RUCKUS Community Forums will be set to READ-ONLY mode starting Sunday, August 9 at 6 PM EDT / 3 PM PDT while we migrate to a new platform.
You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.
Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 10-17.
I have applied a MAC filter and since I updated my firmware the GUI doesn't show my list of filters. However, I do know it is working because when I go to that port only my specific MAC address works on it.
What I did:
- Created MAC filter 1
- Source Address: I used the full MAC address of a specific network computer
- Source Mask: ff-ff-ff-ff-ff-ff
- Destination address/Mask: 00-00-00-00-00-00
- Click Add and got the "The change has been made"
Now I want to apply it to port 11 on my ICX switch so:
- Click "filter group"
- Unit 1 port 1/1/11
- Filter ID List: 1 (because this is what I named my mac filter above)
- Click Add and got the "The change has been made"
Now I want to see my list of these filters so I click show and get "There are no filter group entries"
This used to show me my entire list of filters I had applied. How do I know if port 11 has the filter working or not?
It must be working because I tested a spare laptop and it for sure can't get on the network when plugged into port 11. However, the computer with the MAC address I typed in does work just fine.
