I am attempting to deploy a new environment and I have a fresh ICX 7150 stack (two switches) that are having problems. I don't know if I have a bad unit so I wanted to check with the community to see if anyone else has stacked switches on 8.0.92 or 8.0.92c. First, once the stack is created, and after a period of a few hours, I can no longer configure the stack using the SmartZone 100. I get "Switch configuration update failed" alarms. Eventually the active member will reset its configuration and go back to factory defaults. It loses everything, the SZ configuration too. I currently have an open ticket with support. They have suggested that I downgrade the firmware to 8.0.90f. I will try that later today but first wanted to check with the community in case anyone else is seeing odd behavior with ICX stacks, firmware 8.0.92, and SZ100 (on 126.96.36.199.685).
I confront few months before a huge problem with ICX7150 and ICX7250. My stack was with two ICX7250. I had also the same thought with you, i was not sure if i had bad units. The firmware of mines was older so i tried to upgrade it to 8.0.92 with no success. So i upgraded them to 8.0.90dufi and not to 8.0.90f if i remember well. The funny thing is that the one of the two stacked switches(ICX7250) couldn't go back to factory default even though i tried many times to reset it.
I have now tried three firmware versions on the ICX switches (8.0.90f, 8.0.92, and 8.0.92c) and two on the SZ 100 controller (188.8.131.52.685 and 184.108.40.206.699). I am unable to manage switch stacks from the SZ 100. Any changes made are not applied to the switch.