ICX 7150-C12P, stuck in boot mode

[MikeyH]

icx 7150 stuck in boot mode. Have tried software recovery and all i get is the following in Putty:

Ruckus Networks Bootloader: 10.1.18T225 (Jul 13 2020 - 01:53:18 -0700)

Booted from partition 1
DRAM: Validate Shmoo parameters stored in flash ..... failed!
R04. Configure reference voltage
R08. ZQ calibration

[Imran_ruckus]

Hi @MikeyH 

Greetings!

Thank you for contacting RUCKUS Lennar Home Community.

I hope this message finds you well.

I noticed that you have raised another post on the Lennar forum (please refer to the link below). Kindly follow the same thread, and I will be happy to assist you further there.
https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/ICX-7150-Ap-went-down/m-p/10...

Thank you again for your understanding.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community