After ICX 7150 c12p factory reset need help assigning Ip address and basically setting everything

[mpyrtle]

Hello. I had to reset my ICX switch to factory and now I need a walk through to set everything back up.

I am able to get to the switch via the command line with USB-C to from the switch to my laptop. I was able to create a new password after the reset but I really don’t understand or know the commands like that to assign the IP address, default gateway, and TFtp. I have download putty and TFTP but as of now I’m stuck on assigning a IP address to the TFTP on the switch. 

The commands I found on the forums seems to not work when trying to assign IP address. I just need a up to date or someone to speak to help assist getting the switch not the AP back functioning from the Lennar setup please

[Mayank]

Hi mpyrtle,

Thank you for reaching us.

Could you please confirm us if you are from Lennar Homes.

For Lennar accounts we have a separate page where you can always feel free to reach us and post your queries.

Please refer the below link for posting your queries for Lennar.

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/bd-p/lennar

I hope this information helps you

Please feel free to leave us a message if any concerns