8200 sw10.0.10 Remote CLI

[sterlingj]

Hello everyone,

We recently received some ICX8200-24F's (running sw:10.0.10T25) and while configuring I've run into the common experience of commands changing in the CLI vs pervious versions (our other 7150's are running v8). I've adapted pretty well but haven't been able to figure out the replacement for 'ip address x.x.x.x x.x.x.x' for management on an in-bound port. My goal is to be able to telnet/ssh into the switch through one of the uplinks, and not the management OOB interface. Any suggestions?

Thanks in advance!

ps: i've tried creating a loopback and attaching my desired ip to that loopback and the switch crashes everytime. Commands I'm running is 'int loopback 1' > 'ip address 10.3.4.114 255.255.254.0' after that it goes unresponsive and crashes. Not sure if the crash is typical/expected behavior.

[BenBeck]

Hey @sterlingj,

It sounds like this needs some formal investigation. Can you please open a support case, so we can properly take a look? Please see my signature. 

[sterlingj]

Hi Ben,

Thanks for the quick response. I have opened a formal case.

.