08-22-2021 01:26 PM
Why is my switch not powering the access points?
08-22-2021 01:32 PM
If you run image older 080.80 you need to use this command
interface eth 1/1/x
Otherwise please type show inline power and show as the result
08-23-2021 10:59 AM
What if the switch won’t transmit its own WiFi to be able to access the software settings?
08-24-2021 12:10 AM
I think you mean you can not access the AP like ping or HTTP; so you need to be sure your pc and AP are in the same VLAN and your pc have the same range of networks like ( the pc IP 192.168.1.10/24 and the AP IP 192.168.1.11/24 so you can access the AP in the switch Succesful.
08-23-2021 11:58 PM
You need to enable poe on the interfaces like Mohammad mentioned.
Hope this helps