If you have a Ruckus AP, and not an OEM'd unit with customized configuration from an ISP,
you can try following these instructions I wrote a long time ago.
If you want the 7111 to be used as a CPE to a Ruckus AP
other than a 7811 metro
gateway AP, you can follow these setup steps. Assuming you have a ZoneDirector
and 7962/7762 dual-band or 7363 802.11a/n capable access
points, you can configure
the 7111 to connect with a secure WPA/WPA2 with AES
pre-share key WLAN.
1. Default IP of the
7111 is 192.168.2.254, so manually give your PC/Laptop a
192.168.2.x
(anything but .1 or .254). Press the
indented Hard Reset button on
a 7111 for 8
seconds, to reset it to factory defaults.
2. Connect your
PC/Laptop to the 7111. Ping
192.168.2.254 to determine when it is up.
3. Open a browser to
https://192.168.2.254 , allow/confirm security
exceptions.
4. Login with
super /
sp-admin credentials.
5. Go to
Administration::Management page, and Disable Link-Local Adapter
Management, and
Update Settings. This will allow you to
set static IP or DHCP
management
address. Also disable Auto-Provisioning,
or your manual configuration
will not take.
6. Go to
Configuration::Device. Specify whether
to use Dynamic IP (DHCP) or disable
it, and set a
static IP address/netmask/default-gateway that matches the VLAN info
of the ZoneDirector WLAN. Use Update Settings to keep changes.
[ If you set a
new static IP address, you need to re-address your Laptop, to continue
configuration
with
https://;. ]
7. Go to Configuration::Wireless
page. Set your country code to United States
and c...
