cancel
Showing results for 
Search instead for 
Did you mean: 

Cannot Log In to my R700 Access points after Firmware upgrade

kornel_steyn
New Contributor II
I have upgraded my Zone Director and APs from version 9.9.0.0 update205 to zd1100_9.10.1.0.59.ap_9.10.1.0.59. After the upgrade I cannot log onto my 3 AP's I have on my network.
12 REPLIES 12

In the case that you can't via the browser, but have access via cli, you can issue the following from the command given by Anusha in the debug menu of the ZD:

rksap_cli -A "set http/https enable"

Note: -A is to issue the command to all AP's. If you want only specific AP's use the -a command:

rksap_cli -a aa:bb:cc:dd:ee:ff "set http/https enable"

Note: on certain firmware version you have to use single quote as opposed to double quotes when issuing the rksap_cli command form the ZD

I should also have mentioned that this issue management issues (both web and ssh) predominantly effected MESH AP's, and in my experiences the reboot solved the problem in 100% of my cases.

alan_rothenstre
Contributor
In the new firmware since 9.10 if your AP is managed by a controller, ZD, SZ, vSZ, then the AP GUI is disabled by default. You will have to enable it using the cli. 

matthew_dines
New Contributor

Thanks guys. It is on Unleashed firmware, so no ZD. Looks like an RMA from here.