01-30-2024 09:00 AM
Hello..
I have Ruckus 7055 with standalone firmware 104.0.0.0.1347
And my ZD300 firmware version is10.0.1.0 build 151.
I already reset 7055 to factory default, ssh to 7055 and give command set director ip x.x.x.x and then reboot, but looks like 7055 can no reach ZD3000, I can ping ZD3000 from inside 7055.
Any help would be appreciated.
01-30-2024 09:26 AM
Here is from support info on 7055
apmgr/apmgr-primary-ac-ip-addr='203.84.158.188'
Name : RuckusAP
Tunnel/Sec Mode : L3 (Unknown) / Undecided
State : SULKING
Join failure reason : No any ZD found (didn't rcv any discovery response)
Suggestion : if AP isn't standalone mode, check your network and ZoneDirector
Timer : Silent, expires in 17 secs HW/SW Version : 27.0.0.0 / 104.0.0.0.1347
01-30-2024 12:55 PM
Hi @eko_budhi_harso , Could you please share the complete output. The AP enters in to SULKING state when it is unable to discover the zone director. AP discovers ZD using discovery request packets. If a discovery response is not received after sending the maximum number of discovery requests, the AP enters the Sulking state.
In addition to above, could you please also share the following :-
1. get director
2. Do the AP and ZD communicate over a VPN tunnel? This is to rule out any MTU issues caused by tunnel overhead.
3. Could you please confirm if LWAPP (UDP 12222/12223) and SSH ports are allowed between the AP and the ZD?
Regards,
02-01-2024 08:41 AM
Hello..
Finally found the cause, the Wifi country code and zone director country code is different, no wonder they can not connect.
02-01-2024 09:28 AM
Hi @eko_budhi_harso ,
Thanks for the update. Yes, the country code on Controller and the AP needs to match as well. If your AP is not fixed-country code based, you can change it using "set countrycode xx" CLI command from AP.
Regards,