06-07-2021 02:05 AM
Ruckus R750 device support WPA3?
06-07-2021 02:22 AM
rkscli: set encryption wlan8
Wireless Encryption Type: [0] quit, [1] OPEN, [2] WEP, or [3] WPA
Wireless Encryption Type: 3
WPA Protocol Version: [0] quit, [1] WPA, [2] WPA2, or [3] AUTO
WPA Protocol Version: 2
WPA Authentication Type: [0] quit, [1] OPEN (PSK), [2] EAP (.1X), or [3] AUTO
WPA Authentication Type: 1
WPA Cipher Type: [0] quit, [1] TKIP, [2] AES-CCMP, or [3] AUTO
WPA Cipher Type: 2
WPA PassPhrase: "12345678"
Enter A New WPA PassPhrase [8-63 letters], or Press "Enter" to Accept :
WPA no error
OK
rkscli: exit
Quit:
The datasheet for the r750 says it supports wpa3, but there is no wpa3 in the settings.
06-07-2021 09:54 AM
What version of code is on the AP. I think within the vSZ at least, it needs to run at least 5.2.1. It is definitely an option with 5.2.2 vSZ code on the AP.
rkscli: get version
Ruckus R750 Multimedia Hotzone Wireless AP
Version: 5.2.2.0.1016
OK
rkscli:
rkscli: set encryption wlan 33
wlan: Invalid wlan interface name
rkscli: set encryption wlan33
Wireless Encryption Type: [0] quit, [1] OPEN, [2] WEP, or [3] WPA
Wireless Encryption Type: 3
WPA Protocol Version: [0] quit, [1] WPA, [2] WPA2, [3] AUTO (WPA+WPA2), or [4] WPA3
WPA Protocol Version: 4
06-07-2021 12:03 PM
Hi Suhyeon,
What Brian mentioned is correct. AP needs to be on a software version where WPA3 encryption is supported.
Below are the versions for different RUCKUS wireless controllers on which WPA3 is supported.
Unleashed: 200.8 and above
ZoneDirector: 10.3.0 and above.
v/SmartZone: 5.2.0 and above.
06-07-2021 05:49 PM
Thanks to reply brian, syamantak.
The version is currently 114.1.0.0.
It is being used by updating with solo AP standalone f/w without smart zone.
What version should I download if I am using AP alone?