H500 keeps updating configuration

[Anonymous]

I have a SCG SmartZone 104 with OS version 3.4.2.0.152 ( the recommended one).
I have a Cisco network. I have configured the DHCP server with option 43 related to Ruckus.
Now I plug in R500s and it gets an IP adress and loads the OS and the configuration and works fine.
When I plug in the H500s it gets an IP adress, gets detected by the SZ but keeps in the updating configuration phase. As you can see in the attached picture, it keeps updating the configuration until it is disconnected.

Thank you for your attention, 

[Anonymous]

Hi yassine.

If it works bad onto only H500, it may bug.

In workaround, make some ap-group having only 5Ghz SSID and the H500s move to the ap-group.

Try it.

I have exprienced similary symptom on 3.1.x version.

Regards. 

[Anonymous]

Disabling ap-cert-check in vSZ worked for me on this issue.

[Anonymous]

Hi,

The solutions is to change the Country code to the one that it came with and disable ap-cert-check.

Regards