CPU at 100% sometimes
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2017 12:56 AM
Hello all,
is that normal use of our ZoneDirector 3000 ?
We have some bad experiences with our wifi since the past few days and I saw that the CPU is sometimes at 100%, which is not normal on my mind...
Is that the ZD3000 is ok for 229 APs and almost 800 clients ?
Thanks a lot for your help guys 😃
Have a good day.
is that normal use of our ZoneDirector 3000 ?
We have some bad experiences with our wifi since the past few days and I saw that the CPU is sometimes at 100%, which is not normal on my mind...
Is that the ZD3000 is ok for 229 APs and almost 800 clients ?
Thanks a lot for your help guys 😃
Have a good day.
10 REPLIES 10
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2017 01:38 AM
Check the uptime and firmware version running on the ZD3000.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2017 01:42 AM
Firmware version : 9.12.0.0 build 336
Uptime : 202d 17h 54m
Uptime : 202d 17h 54m
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2017 02:49 AM
9.12.0 is a GA release upgrade ZD3000 to MR release.
https://support.ruckuswireless.com/software/1181-zd3000-9-12-3-0-61-mr3-refresh3-software-release
https://support.ruckuswireless.com/software/1181-zd3000-9-12-3-0-61-mr3-refresh3-software-release
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2017 03:00 AM
That's bizarre. We are running from a 3000 v9.9.0.0 build 216. Today we have a large event with just under 400 hosts across 9 SSIDs. We route all traffic back via the ZD too. My CPU is running at c. 10%. Capture below.