Bandwidth Control
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-11-2015 08:54 AM
I know how to tell how much bandwidth an AP is using - but how can I tell what a specific user is doing? Basically, how can identify someone that is abusing the system and can I rate limit them without banning them? Is there any way to automate that procedure?
7 REPLIES 7
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-29-2015 04:51 PM
Thank you. That at least answers my question and stops me thrashing around looking 🙂 ... unfortunately all I have are 7363s.
Thanks again. That was helpful.
Thanks again. That was helpful.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-07-2015 02:27 AM
For completeness the "show details" button does provide more numbers. As below...
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-07-2015 10:49 PM
Thanks - Let me try that.

