What model of AP please (has a "uid dir that does not blink")?
Are you using a power supply, power injector, or a PoE switch? Does changing the cable to the AP help? Does changing the port on the PoE switch help?
If you pre-configure your PC/laptop with a 192.168.0.10 IP address, and directly connect to the AP with Ethernet, after holding down the indented Hard Reset button on the AP, does it answer a ping to 192.168.0.1 eventually?
If so, try SSH and see if you can login with 'super' and 'sp-admin' uid/pw. If you login successfully, you can "prime" your AP with ZD info and then reconnect it to your network:
set director ip a.b.c.d reboot
And put it back on your network that can talk to the ZD at this point. Does that help?
Hello. You will find here a picture for the access point .you see that the led "dir" is not blinking, that is, the access point does not search a controller and it not difuse any ssid "ruckus wireless"
My curent upgrade is 184.108.40.206.642 I try to upgrade the ap to the upgrade 220.127.116.11.1 but the ap refuse all upgrades. I think the problem is not problem of upgrade because the led dir not operate, it's not a probléme of cable because the ping is passed between the ap and the zd
That doesn't look like a "new" T301 AP..., but unless APs get connected to controllers (or configured manually) they won't broadcast any ssids, correct.
I recommend that you try to connect directly with a pre-configured PC/laptop as described above. The factory default button you need to push, is inside where the Eth cable connects. (doe AP work correctly?)
Second, can you take the red cable from your AP and connect it to a PC/laptop set to receive DHCP, and can you ping your ZD after it receives an IP address? (check network connectivity to ZD?)