ZF7731 and ChannelFly

[miroslav_hadari]

Hi,

Does 7731 automatically changes channels when there is interference on current channel and channel with better signal exists? Does it use ChannelFly?

Firmware version 9.2.0.0.168.

I see in CLI there is command channelfly mtbc, when I use it I get:

rkscli: get channelfly mtbc wlan1
wlan1 mtbc: 100
OK

And this value can be changed, so the command is usable.

I know that SmartSelect works only on power up or when manually triggered, but most of Point-to-Point equipment (even the cheaper ones) have possibilities to automatically scan the channels and change them as interference changes.

This would basically be ChannelFly, does 7731 have that possibility?

And can you please post release notes for firmware 9.2.0.0.168 for ZF7731 I can't seem to find it?

[rahul_koul]

hi

[miroslav_hadari]

Is this problem that Shannon has, linked to software version .168?

Additionally, what about my original question regarding ChannelFly an ZF7731? Does 7731 have that feature?

[ramprakash]

Miro,
As far as i know, Channelfly algorithm is not used in ZF7731.
Shannon issue is not linked to B168(it has some security fixes) as major reason for this issue is interference.

[matthew_mills_5]

Can I request that the auto reboot commands are added in to the GUI please?